LRT_GraphicsSave_The_Riders_DunesUTV_Crazy
Page 6 of 6 FirstFirst ... 456
Results 51 to 54 of 54
  1. #51
    Competent Driver Turtle Tim's Avatar
    Join Date
    Jun 2015
    Location
    Oregon
    Posts
    352
    After posting the above pics I noticed a wear spot on the spider just below the roller. Didnt notice it at the dunes. Just went out and checked the arms, and sure enough, there were wear marks on the head of the weight screw where it was hanging up on the spider. Two of the flyweights were doing this. I loaded up the what Heelclicker told me to load on the arm.
    Thinking this is what destroyed my primary.
    Still think they used soft steel for the flyweights.
    I ran my SLP on flat spotted rollers for a while and the flyweights did not show any wear on them, but these wore out in about 20 miles.

  2. #52
    Crackerjack Driver Beach Leo's Avatar
    Join Date
    Apr 2015
    Location
    Mt Diablo & Mt Shasta
    Posts
    1,471
    Yep Guess Crazy was right

    Non Harden Steel

    Or that china made steel

    So what Damage or do you have to replace on Clutch to get her back to new condition?
    'It's easier to fool people than to convince them that they have been fooled.'

    Mark Twain

  3. #53
    Competent Driver Turtle Tim's Avatar
    Join Date
    Jun 2015
    Location
    Oregon
    Posts
    352
    Replaced the primary with a brand new one at Dunefest. The rollers and pins were destroyed. Might be able to rebuild the old one and have it as a spare.

  4. #54
    Crackerjack Driver Beach Leo's Avatar
    Join Date
    Apr 2015
    Location
    Mt Diablo & Mt Shasta
    Posts
    1,471
    That is a Hard Lesson

    Really Sucks you had to buy new primary Tim
    'It's easier to fool people than to convince them that they have been fooled.'

    Mark Twain

Page 6 of 6 FirstFirst ... 456

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •