Rubicon August 17-19 2018

[Kbachell]

I don’t use any tools.... except to loosen up the lock ring. I blow off the threads with air, brush threads with toothbrush, WD40 the very bottom of the spring where it touches the plate. Then rotate the springs which move the collar down. Adjusted all 4 in about 1-1-5 hours


Sent from my iPhone using Tapatalk

This new tool got all four adjusted in 15 minutes... well... after taking 45 minutes to make the tool... I just cleaned the threads, and used some of my Gun Cleaning/Lubricating spray and then spun them down with my "crows foot" with a floor jack lifting the vehicle to relieve pressure from the spring.

[Airbus899]

This new tool got all four adjusted in 15 minutes... well... after taking 45 minutes to make the tool... I just cleaned the threads, and used some of my Gun Cleaning/Lubricating spray and then spun them down with my "crows foot" with a floor jack lifting the vehicle to relieve pressure from the spring.

Dang that is fast!! U should make another one of those tools Ken & sell it to me. Lol


Sent from my iPhone using Tapatalk