New belt change problem, 16' xp4 na

[Jeepalive]

So I changed out an old gates belt that threw the codes for misfire and made me go into limp mood, last time it did this the belt blew apart a mile later so this time I changed it for a new gates went out today and I would be going fine let off the gas and it would like bog down even back fired a few times but if I got on the gas again everything was fine, then I would be going get up to about 45 and it would not going any faster almost like it was slipping?
Not sure what it could be, any ideas?
I will be ordering a factory belt maybe the gates aren't good like I heard.

[Mike621]

That's where I would start Scott, also maybe Polaris has an upgraded belt, hopefully it's that easy. [emoji1417]


Sent from my iPad using Tapatalk

[Controlled Force]

I've seen good and bad reviews regarding Gates belts that's why I never give an opinion on them .
Get a factory Polaris belt disconnect your battery for 10 minutes to clear the codes and then hook it back up and go for another test drive, post results afterwards

Sent from my SM-N900P using Tapatalk

[Controlled Force]

Another thing to check are the 3 rollers in the primary clutch that the 3 arms ride on, when they get flat-spotted the arm will hang up and hold the clutch open and not work correctly

Sent from my SM-N900P using Tapatalk

[Jeepalive]

I've seen good and bad reviews regarding Gates belts that's why I never give an opinion on them .
Get a factory Polaris belt disconnect your battery for 10 minutes to clear the codes and then hook it back up and go for another test drive, post results afterwards

Sent from my SM-N900P using Tapatalk

I don't have any codes right now, I'll check the rollers when I swap out the belt this week and post up what I find.
Thanks for the input!

[Jeepalive]

This might be my problem....
Dirty Dog Clutch
1000 miles
https://uploads.tapatalk-cdn.com/20170829/10c3a67f6825a38b343455237766ac00.jpg
https://uploads.tapatalk-cdn.com/20170829/251109e3761b718bf3ef8b29b3762485.jpg
https://uploads.tapatalk-cdn.com/20170829/d6027068d0b0b3b8c97d6e340e3bdf7f.jpg

[Mike621]

Yeah I think that just might cause some problems Scott. [emoji51] at least you found it. [emoji1417]


Sent from my iPad using Tapatalk

[Jeepalive]

Another thing to check are the 3 rollers in the primary clutch that the 3 arms ride on, when they get flat-spotted the arm will hang up and hold the clutch open and not work correctly

Sent from my SM-N900P using Tapatalk

Inbox is full

[Controlled Force]

Inbox is fullEmpty now

Sent from my SM-N900P using Tapatalk